Many yards are surrounded by concrete cinder block fences . While they are fantastic at supply privacy , they are not generally attractive . Adding hanging plants to your concrete cinder block fencing is one fashion to weaken its looking and lighten up the entire region . But it is somewhat more complicated to attach plant hanger to a concrete clinker block wall than to one made of a softer material . Masonry anchors clear this problem . To buy Freemasonry ground tackle that will be strong enough , weigh each plant and divide the weight by the figure of provided prison guard holes in each plant life hanging come-on . Select masonry linchpin that can each endorse this much unchanging shear load and are small enough to fit through the holes of your flora hangers .
Step 1
put the flora hanger against the bulwark and arrange it until you are quenched with where it is . Use a tier to ensure the hanger is plumb and layer . Draw a dot inside each fuck yap at the base of the hanger using chalk , and then pull the hanger by to hold back you’re able to see the marks on the concrete cinder blocks .
Step 2
mark off the diam of the Freemasonry backbone and tie a masonry exercise bit of the same diam to your practice session . bore a hole at each chalk mark that is slightly deeper than the length of the lynchpin . Wipe away masonry dust from the Earth’s surface of the wall with a rag after you have terminate drilling .
Step 3
Fit a masonry anchor into each prepared hole . Hammer the anchorman in until they are loaded with the surrounding wall . Remove the masonry bit from the drill and attach a piece of tail bit appropriate for the nooky you are using .
Step 4
Step 5
station the plant life hanger against the wall and trace up the screw holes with the anchors . practise a screw into each anchor . Tug down gently on the hanger to ensure it is securely affix , and then hang your plant .
References
Related
